Garage. Friday , October 20th , 2017 - 18:46:13 PM
In the past, the biggest concern with operating an overhead garage door was the potential risks associated with the springs used for balancing the door weight. Pre mid 1960’s garage door installations typically relied upon a pair of stretched (tensioned) springs to assist the operation of the garage door pivoting hinges. These springs became loaded (tensioned) as the door was moved into the closed position. Unloading (releasing) of the stored spring energy occurred as the door was opened to the horizontal overhead position. One of the most dangerous aspects of these spring systems was that after a period of time, often without any maintenance or inspection, the points of attachment of these springs would rust or become weak. This weakening of the springs or points of attachment would often lead to an inadvertent explosive failure flinging the broken spring components across the garage, embedding the spring or steel components into the garage walls, cars or other items in the path of travel. Unfortunately, sometimes people were in the path of travel of these explosive occurrences. As these springs failed, as an attempted safeguard, some manufacturers devised a "caging" system for the springs. These cages were retrofitted onto the stretched springs in an attempt to capture the parts that would release if a failure occurred. While these caging devices were helpful, they were not completely effective. Some of these spring devices are still in use today. Whenever this condition exists or the quality of garage components are questionable, a qualified professional service technician should be consulted.
In contrast to an overhead type of garage door, be it sectional or single panel, roll up doors have a totally different type of operating system. When these doors are used, they can be concealed in an overhead or under mounted trough. These doors operate similarly to a roll top desk door except for how they are stored when not in the closed position. They normally coil as they are retracted, and require significant gear trains to reduce the effort required to move these doors up and down into position. Often the forces needed to move these roll up doors require a reduction type of transmission that allows a very heavy door to be operated effortlessly. These doors can be chain driven either manually, or can be automated using electric motors. Roll up doors require more frequent evaluation and servicing than a standard overhead garage door. The tracks that are mounted vertically on both sides of the garage opening need maintenance and cleaning more frequently, and are often blocked by foreign obstructions or damaged by collision of some type. These roll up doors are often held open by some type of ratcheting action. Proper balancing of these doors is often more important than an overhead type of door, as the weight of these type of doors is normally much greater than an overhead door.
Sizeing Rubbermaid FastTrack Garage Organization Systems, There are two ways to size your custom design of the Rubbermaid FastTracks garage system. The first is to pick all the garage storage products you would like to have and then figure out what length rails you will need and where to place those rails in your garage. The second method is to predetermine where you would like to place the tacks in your garage and then select garage storage racks, shelves, baskets, etc... to fill it in.